|
425 Horsepower PUMP GAS SPECIALChevy 383 - 425 Horsepower
Long Block
Assembly
$4,495.00
|
 |
| Part |
Manufacturer |
Description |
| DES383C |
|
425 HP - 383 Stroker Motor |
| Block |
DES |
4 Bolt, seasoned core, cleaned, magnafluxed, decked w/BHJ fixture, bored, honed w/BHJ torque plates,
brass freeze plugs and cam bearings installed,
right hand dipstick, painted black standard,
orange available, ask. |
| Crank |
SCAT |
New, cast steel 9000 series, 3.75" stroke,
1 pc. rear seal |
| Pistons |
Federal Mogul |
Hypereutectic, Flat
top 10.4 compression
w/64cc head |
| Rings |
Federal Mogul |
Moly, non-file fit |
| Rods |
SCAT |
5.7 I-Beam, forged 4340 steel, full floating pin, 187,000 psi
3/8 cap screws |
| Bearings |
Clevite 77 |
Cam, rod and main bearings |
| Heads |
Edelbrock |
200cc E-Tec Heads,
aluminum, straight plug, 64cc, 2.02 and 1.60
valves, 10 degree retainers and keepers, CNC
port matched intake and exhaust ports, up to
.575" lift, 1.460" springs, complete heads |
| Rocker Arms |
Scorpion |
Aluminum, full
roller 1.5 ratio, 3/8" stud |
| Pushrods |
TrickFlow |
High performance, hardened, chromemoly, 5/16"
one piece. |
| Cam & Lifters |
Lunati |
Hydraulic flat tappet,
.507"/.477"
lift, int. 275 deg., exh.
285 deg., on small base circle |
| Bolts |
Pioneer |
High performance head and main bolts |
| Timing Chain |
Cloyes |
Heavy duty 1/2"
single roller |
| Timing Cover |
Milodon |
Gold stamped steel
to match pan |
| Gaskets |
Felpro/Corteco |
High performance, mixed set, one piece oil pan gasket |
| Oil Pan |
Milodon |
Stock style, 7 1/2" deep sump, 5 quarts + filter capacity, gold finish |
| Oil Pump |
Melling |
High Volume M55HV |
| Pump Drive |
Melling |
Heavy duty with steel bushing |
| Pump Pickup |
Melling |
Standard screen, welded to pump |
| Dampner |
Pioneer |
OEM style, 400, external balance |
| Flexplate |
Scat |
SFI approved, 400, external balance, 168 teeth, 14.13" diameter,
153 teeth available |
| Balance |
DES in-house |
High performance
street/strip, piston and rods matched +- 1 gram |
|
Upgrade to
Custom Grind Hydraulic Roller Cam & Lifters: ADD $525.00 |
|
Motor completely assembled. |
| All motors require 50% deposit to begin building and balance paid prior to shipping. All motors are shipped
in continental USA excluding Alaska for $250.00 additional. Warranty is provided by manufacturer if a warranty exists. These motors are
custom built for each customer and are considered race only, non-emissions compliant, and customer assumes all liability while operating. |
|
